Halloween Kitty Ghost on Heavenly Cloud

Thinking of kitty recently?
Such a sweetie kitty was...

Kitty is ready to watch over you from a heavenly cloud while you work, study and game. Your guardian angel.

The cloud has a flat base and kitty slides perfectly into place without falling over or sliding out.

Print flat base kitty first (easy) then try the rounded (intermediate) kitty.

Cloud base has flat bottom and prints well (easy).

RIP "Mittens'!

Happy Halloween!

3D PRINTING SETTINGS

Printed on an Elegoo Neptune 3
Important settings that worked well:

Nozzle Temp: 220°C
Bed Temp: 60°C
Flow: 100%
Print Speed: 60mm/s
Initial Layer speed: 10 mm/s

Supports: Normal, Concentric
Support Overhang Angle: 50°
Layer height: 0.2mm
Line width: 0.4mm
Initial Layer Line Width: 100%

Wall Thickness: 2mm
Top/Bottom Thickness: 2mm

Infill Density: 12%
Infill Line Distance: 3.33mm
Infill Pattern: Gyroid

Adhesion: Brim
Draft Shield: Enabled, 10mm distance, 10mm height

*Adjust settings as needed and remember to check Z-offset after leveling, happy printing!