The Batman Bookend

Thank you for supporting the Batman Bookend, handmade in VR, from Kimchi Studios!

You need a hero to save your books from falling from Gotham tower!

I put out a signal and the dark knight himself showed up to get the job done.

Our caped crusader holds his cape closed, at rest, with his left arm, ready to pounce on any attempt gravity makes to steal your library.

Print 2 Batman Bookends to keep your precious collection in check.

Scale as needed, the bigger the better!

Includes 1x Whole Batman Bookend stl file and a 3 part with round connector set for the bottom, mid, and top pieces. Try the whole file first.

See more original designs and educational videos on Youtube and TikTok @kimchistudios

*Successfully printed on a factory stock Elegoo Neptune 3 with matte grey Overture PLA under similar settings:

Nozzle temp: 215-220°C

Layer height: 0.2-0.3

Wall thickness: 0.8-1mm

Bottom thickness: 0.85-1mm

Infill density: 10-15% (higher= heavier bookend)

Infill: Gyroid

Top/Bottom thickness: 2mm

Print speed: 50-70mm/s

Initial layer speed: 10mm/s

Supports: Tree/Organic

Overhang: 70-80­°

Pattern: Lines or Grid

Adhesion: Brim 3mm, Draft Shield 4mm away from print and at least 10mm in height but *raft highly recommended!

**Strong strength glue stick like "UHU stic" applied to build plate highly recommended due to the flat edges of the block!

Print time: approx. ~1 day 3 hours @60 mm/s

*Adjust settings as needed!